LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Electronic Engine Controls - V8 N/A 5.0L Petrol -- XK/X150) >> Electronic Engine Controls - V8 N/A 5.0L Petrol >> Right Heated Oxygen Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2015 Jaguar XK, 2014 Jaguar XK, 2013 Jaguar XK, and 2012 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure the anti-seize compound does not contact the HO2S tip.
    • If accidentally dropped or knocked install a new sensor.
    • Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

    To install, reverse the removal procedure.

  2. NOTE: For NAS vehicles only.

    If required, carry out a long drive cycle.

    Refer to: Powertrain Control Module (PCM) Long Drive Cycle Self-Test  (General Procedures).

scientia non olet · About LEMON Manuals