Removal And Installation: Removal
CAUTION:
Make sure that the orientation and code on the top of the camshaft bearing caps is noted (along with the bank - A or B), so that on installation the components are installed to their original position. Failure to follow this instruction may cause damage to the vehicle.
NOTE:
Removal steps in this procedure may contain installation details.
-
Refer to: Battery Disconnect and Connect
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: Timing Drive Components - Assembly Part Number: INA Timing Drive or Timing Drive Components - Assembly Part Number: TSUBAKI Timing Drive
-
CAUTION:
- Rotate the camshafts until all the valves are at their minimum open point.
- Evenly and progressively, release the camshaft bearing caps.
NOTE:
Remove the camshaft bearing caps.
NOTE:
their position, orientation and markings. Each is marked with its position (number) and an orientation (arrow).