LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - V8 S/C 5.0L Petrol -- XK/X150 >> Engine - V8 S/C 5.0L Petrol >> FLEXPLATE >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect
  2. Raise and support the vehicle.
  3. Refer to: Transmission
  4. CAUTION:
    • Install all the bolts finger tight before final tightening.
    • The bolts can only be used 3 times, mark the bolts with a center punch. If 2 punch marks are visible, discard the bolts.
    • Make sure that no components fall off during removal.
    • Install the bolts in the noted position.
    NOTE:
    • Make sure the crankshaft and flexplate mating faces are clean before installation.
    • Make sure that the crankshaft is not rotated.
    • Tighten the retaining bolts working diagonally.
    G11285085

    Torque Specifications: 

    Stage 1: 45 Nm 

    Stage 2: 90° 

scientia non olet · About LEMON Manuals