Removal And Installation: Removal

1. Remove the cover and disconnect the battery ground cable.

   For additional information, refer to: Battery, Mounting And Cables -- XK/X150 (Specifications).

2. Remove the instrument panel.

   For additional information, refer to: Instrument Panel (Removal and Installation).

3. Remove the windshield wiper arms.

   For additional information, refer to: Wiper Pivot Arm (Removal and Installation).

4. Remove the throttle pedal assembly.

   • Remove the 3 Torx screws.
   • Disconnect the electrical connector.

5. Release the brake switch.

   • Rotate clockwise approximately 30 degrees.

6. Release the brake booster.

   • Remove the brake pedal clevis pin.
   • Remove the 4 nuts.

7. Remove the nuts from the brake pedal bracket.

   • Remove the 5 nuts.
8. NOTE: Working from the engine bay.

   Remove the air intake cover.

   • Remove the 4 clips.

9. Remove the brake master cylinder cover.

   • Remove the 3 clips.

10. Remove the plenum chamber panel.

    • Release the retaining clip.
    • Release the 3 clips.
    • Disconnect the washer jet hose.

Remove the brake pedal bracket.

• Remove sealant for access to the bulkhead screw heads.
• Remove the 4 screws.
• Release the electrical harness clip.