LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake Actuation -- XK/X150 >> Hydraulic Brake Actuation >> Brake Master Cylinder - LHD RWD (G545951) >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install a new O-ring seal.
  2. Install the brake master cylinder.
    • Tighten the nuts to 25 Nm (18 lb.ft).
  3. Connect the brake master cylinder lines.
    • Tighten the brake line unions to 17 Nm (13 lb.ft).
  4. Connect and secure the electrical connector.
    • Tighten the bolt.
  5. Install the brake fluid reservoir.

    For additional information, refer to: BRAKE FLUID RESERVOIR  (Removal And Installation).

scientia non olet · About LEMON Manuals