Inspection And Verification: Notes
NOTE:
Prior to carrying out any diagnosis, make sure that the brake system warning indicator is functional.
Visually examine the front and rear wheel and tire assemblies for damage such as uneven wear patterns, tread worn out or sidewall damage. Verify the tires are the same size, type and, where possible, same manufacturer.
Replace the damaged wheel or excessively worn tire. Refer to: Wheel and Tire (Removal and Installation).
Wheels and tires must be cleared of any foreign matter and tire pressures adjusted to the correct specification.
If the tires exhibit uneven wear or feathering, the cause must be corrected. Check the steering and suspension components for damage or wear and, if necessary, check and adjust front wheel alignment. Refer to: Specifications and Front Toe Adjustment (General Procedures).
Visual Inspection
| MECHANICAL | ELECTRICAL |
|---|---|
|
|