LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Closures -- XK/X150 >> Body Closures >> Luggage Compartment Lid >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install The Luggage Compartment Lid Decal.
    • Remove The Backing From The Decal.
    • Remove The Protective Cover From The Decal.
    • Secure The Decal To The Luggage Compartment Lid.
    • Position And Align The Decal On The Luggage Compartment Lid.
  2. Install The Luggage Compartment Lid Wiring Harness.
  3. Install Both Of The Rear Lamp Assemblies.
    • Install The Nuts.
    • Connect The Electrical Connectors.
  4. Install The Luggage Compartment Lid Finisher.
    • Connect The License Plate Lamp Electrical Connector.
    • Secure The 4 Clips.
    • Install The 4 Bolts.
    • Install The Grommets.
    • Install The License Plate Lamp Housing.
  5. Install The Wiring Harness.
    • Install The 2 Bolts.
    • Secure In The 9 Clips.
    • Connect The Electrical Connectors.
  6. Install The Luggage Compartment Lid Lock Cylinder.
    • Tighten The Torx Bolt To 3 Nm (2 Lb.Ft).
  7. Install The Bump Stops.
  8. Install The Luggage Compartment Lid Latch Assembly.
    • Install The 3 Torx Bolts.
    • Connect The Electrical Connector.
    • Tighten The Bolts To 20 Nm (15 Lb.Ft).
  9. Connect The Luggage Compartment Lid Latch Operating Cable To The Lock Cylinder.
    • Install The Cable.
  10. With Assistance, Install The Luggage Compartment Lid.
    • Install The 4 Nuts.
    • Tighten The Nuts To 23 Nm (17 Lb.Ft).
  11. Install The Luggage Compartment Lid Support Struts.
    • Secure In The 2 Clips.
  12. Install The Wiring Harness.
    • Secure The Electrical Harness With The Clip.
  13. Connect The 4 Electrical Connectors.
  14. Install The Luggage Compartment Lid Trim Panel.
scientia non olet · About LEMON Manuals