Removal And Installation: Installation

1. Install the secondary hood pads.
   • Secure with the clips.
2. Install the hood pad.
   • Secure with the clips.
3. Install the hood seal.
   • Install the clips.
   • Attach the hood seal.
4. Install the hood seal end caps.
   • Secure with the clips.
5. With assistance install and align the hood.
   • Tighten the nuts to 25 Nm (18 lb.ft).
   • Connect the struts and secure with the clips.
   • Connect the struts and secure with the clips.

Align the hood to the pedestrian protection actuators using special tools 501-119.

• Insert special tools 501-119 into the pedestrian protection actuators.
• Loosen the 8 bolts securing the pedestrian protection actuator stops to the hood.
• Gently close the hood so that the pedestrian protection hood stops are aligned to the actuators.
• Open the hood.
• Tighten the bolts to 10 Nm (7 lb.ft).