Removal And Installation: Installation

• Install the Antenna.

1. Install the nut on the top of the Antenna.
2. Install the 2 bolts to the Antenna mounting bracket.

   Torque specification: 10 Nm

• Install the drain tube.
• Install the bolt to the earth strap.

Connect the wiring harness electrical connectors.

Install the Hydraulic Pump Assembly.

For additional information, refer to: Convertible Top Motor (Convertible Top, Removal and Installation).

For additional information, refer to: Rear Quarter Trim Panel - 2-Door (Interior Trim and Ornamentation, Removal and Installation).

For additional information, refer to: BATTERY DISCONNECT AND CONNECT (Battery, Mounting and Cables, General Procedures).