LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XK 2D Convertible >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension -- XK/X150 >> Rear Suspension >> Rear Wheel Bearing - (XKRS Gt) >> Removal And Installation >> Installation

Removal And Installation: Installation

    NOTE: Make sure correct alignment of the bearing is maintained when installing into the hub carrier.
  1. G11283918

    Special Tool(s):  204-727A, 204-791

  2. G11283916
    3. NOTE: Make sure the correct alignment of the drive flange is maintained when installing into the hub carrier and bearing assembly.
  3. G11283920

    Special Tool(s):  204-726, 204-250

    4. CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.
  4. G11283913

    Torque Specification: 96 Nm 

    5. CAUTION: Install the halfshaft nut finger tight.
    NOTE: The wheel hub nut is not tightened at this stage.
  5. G11283906
    6. CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.
  6. G11283911

    Torque Specification: 190 Nm 

    7. CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.
  7. G11283857

    Torque Specification: 63 Nm 

  8. G11283909

    Torque Specification: 6 Nm 

  9. G11283620
  10. G11283907

    Torque Specification: 103 Nm 

    11. CAUTION: Do not use air tools to install the nut. Failure to follow this instruction may result in damage to the component.
  11. G11283906

    Torque Specification: 

    Stage 1: 150 Nm 

    Stage 2: Loosen: 1/4 turn(s) 

    Stage 3: 80 Nm 

    Stage 4: 60° 

  12. Refer to: Wheel and Tire
scientia non olet · About LEMON Manuals