LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XJ L >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake -- XJ/X351 >> Rear Disc Brake >> Removal And Installation >> Brake Caliper - Vehicles With: High Performance Brakes (G1272011) >> Removal

Brake Caliper - Vehicles With: High Performance Brakes (G1272011): Removal

WARNING: Failure to release the tension and calibrate the electric parking brake during rear parking brake related service procedures, could cause the parking brake to function incorrectly or become inoperative.
CAUTION:
  • Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
  • LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
  1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  2. Refer to WHEEL AND TIRE (Removal and Installation) .
  3. Refer to PARKING BRAKE CABLE TENSION RELEASE (General Procedures).
  4. NOTE: RH side only.
    G11284449
  5. G11284450

    Torque Specifications: 10 Nm 

  6. CAUTION:
    • Always plug any open connections to prevent contamination.
    • If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
    NOTE: To prevent the loss of brake fluid, using the special tool apply the brake pedal and set to 40mm (1.6 in) below the rest position.
    G11284451

    Torque Specifications: 42 Nm 

  7. G11284452
    • Release the 2 clips.
  8. G11284453
    • Release the clip.
  9. WARNING: If the brake caliper piston seal is damaged a new brake caliper must be installed.
    CAUTION: Do not allow the brake caliper to hang on the brake hose.
    G11284454

    Torque Specifications: 28 Nm 

  10. G11284455
scientia non olet · About LEMON Manuals