Drive Away Release (DAR)

With the vehicle static and the electric park brake applied, the DAR (Drive Away Release) mode gradually reduces the clamp load when the accelerator pedal is pressed, without the EPB switch being set to the release position, to assist with a smooth drive away. This mode is only active if either the driver door is closed, or if the driver safety belt is buckled and the engine is running.

The point at which the EPBCM releases the brakes is determined by the following factors:

• Tilt angle - from the inclination sensor in the EPBCM
• Engine torque - from the ECM
• Throttle pedal applied - from the APP sensor
• 'D' (Drive) or 'R' (Reverse) gear selected - from the TCM

DAR operation can be delayed by holding the EPB switch in the applied position, then releasing it at the required time.