Fuel Pump And Sensor Unit (G1086686): Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
- Refer to: Fuel System Pressure Release - V6 S/C 3.0L Petrol/V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol (General Information, General Procedures).
- Special Tool(s): 310-123
-
NOTE:
- Note the position of the locating tang.
- Remove and discard the O-ring seal.
-
CAUTION: Take extra care not to damage the fuel tank level sensor float and arm.