LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XF Supercharged >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Transmission/Transaxle Cooling (V8 4.2L Petrol/V8 S/C 4.2L Petrol/V6 3.0L Petrol)) >> Transmission/Transaxle Cooling (V8 4.2L Petrol/V8 S/C 4.2L Petrol/V6 3.0L Petrol) >> Removal And Installation >> Transmission Fluid Cooler Tubes >> Removal

Transmission Fluid Cooler Tubes: Removal

WARNING: This page is about a different car, the 2010 Jaguar XF and 2009 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Center the steering wheel.
  3. Remove the air deflector. Refer to AIR DEFLECTOR (G1569045) information.
  4. Remove the splash shield.
    GJ0005346
    5. CAUTION: Make sure that all openings are sealed. Use new blanking caps.
  5. Detach the transmission fluid cooler tubes.
    • Remove the 2 retaining bolts.
    • Allow the transmission fluid to drain into a suitable container.
    • Remove and discard the O-ring seals.
      GJ0005347
  6. Detach the wiring harness.
    GJ0005439
  7. Detach the hose.
    GJ0005440
  8. Make sure the alignment mark, on the steering gear pinion seal protection cover, is central to the steering gear pinion casting.
    GJ0003473
  9. Detach the lower steering column.
    • Remove the steering gear shaft pinch bolt.
      GJ0003466
  10. Detach the steering gear.
    GJ0004034
  11. Secure the steering gear.
    GJ0004068
  12. Remove the retaining nut.
    GJ0005441
  13. Remove the left-hand catalytic converter heat shield.
    GJ0005442
  14. Remove the left-hand catalytic converter heat shield retaining bracket.
    GJ0005443
  15. Remove the retaining bracket.
    GJ0005444
  16. Remove the left-hand engine mounting retaining nut.
    GJ0003497
  17. Lower the vehicle.
  18. Remove the engine cover. Refer to ENGINE COVER - V8 S/C 5.0L PETROL (G1090386) information.
  19. Install the special tool.
    GJ0004848
  20. Using the special tools, raise the engine to a suitable height.
    GJ0004849
  21. Release the bracket.
    GJ0005445
  22. Release the transmission fluid cooler tubes bracket.
    GJ0005290
  23. Detach the transmission fluid cooler tubes from the retaining bracket.
    GJ0005446
    24. CAUTION: Make sure that all openings are sealed. Use new blanking caps.
  24. Remove the transmission fluid cooler tubes.
    • Allow the transmission fluid to drain into a suitable container.
    • Remove and discard the O-ring seals.
      GJ0005289
scientia non olet · About LEMON Manuals