LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XF Supercharged >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass, Frames And Mechanisms -- XF/X250 >> Glass, Frames And Mechanisms >> Diagnosis And Testing >> Glass, Frames And Mechanisms >> Inspection And Verification >> Pinpoint Test A: Diagnostic Procedure

Pinpoint Test A: Diagnostic Procedure

  1. A1: DOOR WINDOW - SEAL CONDITION/FOREIGN MATERIAL 

    To check that the door window seal is free from foreign material and has no sign of damage and is not worn in the door channels

    1. Carry out visual inspection for:
      • Foreign material
      • Obstruction
      • Signs of damage or wear to door window seal

    Is the door window seal free from foreign material, damage and wear?

    • Yes  : GO to  A2.
    • No  : Remove any foreign material or were necessary install new door window seal. Test the system for correct operation
  2. A2: DOOR WINDOW - SEAL INSTALLATION 
    NOTE: To check that the door window seal is installed correctly
    1. Check that the door window seal is installed correctly, ensure that it is fully installed into the corner areas

    Is the door window seal installed correctly?

    • Yes  : GO to  A3.
    • No  : Correctly install the door window seal. Test the system for correct operation
  3. A3: DOOR WINDOW - SECURITY 
    NOTE: To check the door window is secure
    1. Check if the door window is installed correctly and secured to the door window regulator

    Is the door window correctly installed and secure?

    • Yes  : GO to  A4.
    • No  : Adjust the door window referring to the door window installation process refer to: Glass, Frames and Mechanisms  (Description and Operation)
  4. A4: DOOR WINDOW - RESET PROCEDURE 
    1. Disconnect vehicle battery, wait for a minimum of 2 minutes, then reconnect the battery
    2. For vehicles pre-VIN S08680  , the latest version of the diagnostic software must be loaded. SDD must be loaded with SDD DVD126_V6. 03 and Calibration File 77 (or later)
    3. For vehicles pre-VIN R54858  , replace the front door window regulator motor, refer to: Front Door Window Regulator and Motor  (Removal and Installation).
    4. With the vehicle engine running, initialize the door window regulator motors, refer to: Door Window Motor Initialization  (General Procedures).
    5. Cycle the window 20 times, using the `one-touch' function to open and close the window
    6. NOTE: The door window regulator motor may thermally cut out after too many operations, if this occurs wait 30 seconds before continuing

    Is door window closing correctly and the One-touch  function operational?

scientia non olet · About LEMON Manuals