| Rumbling noise from the rear of the vehicle varying at different vehicle speed and load |
|
- Rear differential internal failure
- Road noise
- Worn or damaged driveshaft joint
- Wheel bearing
- Another component contacting the front/rear drive halfshaft
|
Using the manufacturer approved diagnostic system run application Noise, vibration and harshness diagnostic test - Rear differential |
| Running at reduced capability with fault present |
|
- Water ingress to wiring harness or connectors
- Reduced differential capability
- Differential increased tolerances
- Internal fault
- Rear differential control module fault
|
Check for stored DTCs and refer to the DTC index. Visually inspect the wiring harness and connectors for water ingress |
| Rear differential overheat |
|
- Oil level incorrect
- Oil level incorrect specification
- Sensor fault
- Internal fault
|
Check for stored DTCs and refer to the DTC index. Check for correct oil quantity and specifications. Refer to the relevant section of the service information |
| Excessive steering effort |
|
- Sticking or stuck actuator
|
Check for stored fault codes and refer to DTC index |