Outer Constant Velocity (CV) Joint Boot - AWD (G1578773): Removal

CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.

NOTE:

Left Hand illustration shown, Right Hand is similar.
Some variation in the illustrations may occur, but the essential information is always correct.

Raise and lower the vehicle on a 4 post ramp.
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
For additional information, refer to: Inner Constant Velocity (CV) Joint Boot - AWD (G1578772) (Removal and Installation).
CAUTION: Use suitable protective covers to protect the halfshaft.

Using a suitable clamp, secure the rear halfshaft.
CAUTION: Make sure the outer constant velocity (CV) joint is not seperated from the halfshaft.

NOTE: Discard the retaining clips.
CAUTION: Make sure the CV joint ball bearings do not drop out of the CV joint.

NOTE: Clean the constant velocity (CV) joint, removing as much of the old grease as possible.