-
CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- Correct preparation of body apertures "post painting" to ensure satisfactory glass adhesion, must be carried out in line with industry practise.
- Prepare the window glass, window glass flange and trimmed PU adhesive in accordance with the instructions included with the PU adhesive kit.
-
CAUTION:
Touching the adhesive surface will impair rebonding.
-
WARNING:
This step requires the aid of another technician.
CAUTION:
- Make sure that the component is correctly located on the locating dowels.
- Make sure that equal pressure is applied to the full length of the component.
- If the ambient temperature falls below 10 degrees C, apply warm air (25 degrees C) continuously for 15 minutes.
-
CAUTION:
Make sure that no excess sealant residue is evident.
- If water is used as a means for the leak check, then allow sealant to dry before testing.
- Spray water around the windshield glass, mark any area that leaks. Dry the windshield glass and sealant before applying additional sealant.
-
- Refer to: Rain Sensor
(Wipers and Washers, Removal and Installation).
- Refer to: A-Pillar Trim Panel
(Interior Trim and Ornamentation, Removal and Installation).
- Refer to: Cowl Vent Screen
(Front End Body Panels, Removal and Installation).