LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XF Portfolio >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Tank & Lines - V8 5.0L Petrol/V8 S/C 5.0L Petrol -- XF/X250 >> Fuel Tank And Lines - V8 5.0L Petrol/V8 S/C 5.0L Petrol >> Removal And Installation >> Fuel Rail High-Pressure Fuel Pump Supply Line (G1589060) >> Installation

Fuel Rail High-Pressure Fuel Pump Supply Line (G1589060): Installation

  1. G11424149

    Connect the new fuel pipe to end of the special tool as indicated.

  2. CAUTION:
    • Install a new fuel pipe.
    • Care must be taken not to damage the component.
    NOTE: This step requires the aid of another technician.
    G11424150

    With the aid of another technician, install a new low pressure fuel pipe using the special tool as indicated.

  3. G11424151

    Inspect the low pressure fuel line for correct fitment and routing as indicated.

  4. G11424152

    Torque Specification: 10 Nm 

  5. G11424153
  6. G11424154

    Remove the special tool.

  7. G11424155
  8. G11424156
  9. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  10. G11424157
  11. G11424158
  12. G11424159

    Torque Specification: 21 Nm 

  13. G11424160
  14. Refer to: Starter Motor (V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol, Removal and Installation).
  15. NOTE: Tighten the bolts in the indicated sequence.
    G11424161

    Torque Specification: 48 Nm 

  16. G11424162
  17. G11424163

    Torque Specification: 12 Nm 

  18. NOTE: If equipped.
    G11424164
  19. Refer to: Air Deflector (Front End Body Panels, Removal and Installation).
  20. Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).
scientia non olet · About LEMON Manuals