LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Convertible Top -- XK/X150) >> Convertible Top >> Hydraulic System, Lift Cylinder And Motor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible top hydraulic pump.
  2. Connect the convertible top hydraulic pump hoses.
    • Install new O-ring seals.
    • Attach the hoses and position the retaining clamp.
    • Tighten the Allen bolts to 10 Nm.
  3. Secure the convertible top hydraulic pump.
    • Tighten the bolts to 8 Nm.
  4. Connect the convertible top hydraulic pump electrical connectors.
    • Secure the electrical connectors to the convertible top pump bracket.
  5. Fill the convertible top pump with the correct amount of fluid.
    • Remove the convertible top fluid filler plug.
    • Top-up the convertible top fluid.
    • Install the convertible top fluid filler plug.
  6. Install the RH loadspace trim panel.

    For additional information, refer to: Loadspace Trim Panel - Convertible

  7. Cycle the convertible top to bleed the hydraulic system.
scientia non olet · About LEMON Manuals