LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Convertible Top -- XK/X150) >> Convertible Top >> Description And Operation >> Introduction

Description And Operation: Introduction

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

The power-operated convertible top consists of a fabric canopy with a 'Thinsulate' inner liner, which is fitted to a steel frame with cast linkages.

The fully automatic flush mounted aluminum tonneau panel conceals the stowed top and incorporates the Roll-over Protection System doors in its trim panel. The top has a low-stack height of 200 mm (7.9 in) and manual roller blind luggage separator to optimize the luggage compartment volume. The open and close time of the top is approximately 17 seconds depending on ambient temperature and battery voltage.

A heated glass backlight is high frequency welded to the canopy.

A pump motor and valve block provides hydraulic power to open and close the top while an electric motor controls a tension bow system to latch and unlatch the top. A single hold-down switch located in the roof console operates the top. This switch also operates the rear quarter glass.

In the event that the top cannot be powered to the raised or lowered position, provision is made for manual operation.

For information regarding convertible top operation, manual operation and the removal and installation of the luggage separator, refer to the Owner's Handbook.

CAUTION: The convertible top frame is located on the vehicle body accurately using a steel adjuster plate; under no circumstances must the top steel adjuster plates be released. For more information refer to the adjuster plate section.