LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Convertible Top -- XK/X150) >> Convertible Top >> Convertible Top Striker >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible to latch striker.
    • Install the Torx bolts, but do not tighten fully at this stage.
    • Connect the electrical connector.
    • Secure the wiring harness clip.
  2. Install the header rail.
    • Tighten the screws.
  3. Secure the convertible to latch striker.
    • Tighten the Torx bolts to 23 Nm (17 lb.ft).
  4. Install the header rail upper trim panel.

    For additional information, refer to: Header Rail Upper Trim Panel 

  5. Close the convertible top.
scientia non olet · About LEMON Manuals