LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Convertible Top -- XK/X150) >> Convertible Top >> Convertible Top Material >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible top outer material.
    • Secure the convertible top material to the frame.
  2. Secure the front edge of the convertible top material.
    • Install the Torx screws.
  3. Secure the convertible top outer material retaining straps.
    • Tighten the Torx bolts to 6 Nm (4 lb.ft).
  4. Feed the tension cables through the convertible top outer material ensuring the correct routing.
    • Attach the tension cables to the convertible top frame.
    • Install new clips.
  5. Secure the convertible top to the rear seal.
    • Carefully open the rear seal sufficiently to locate the convertible top outer material.
    • Attach the convertible top outer material.
    • Clamp the seal to retain the outer material.
  6. Install the convertible top side seal carriers.
    • Install the rivets.
    • Attach the seal.
  7. Install the convertible top front seal carriers.
    • Install the spacers.
    • Tighten the new Torx bolts to 6 Nm (4 lb.ft).
    • Attach the seal.
    • Tighten the Torx screws.
  8. Install the convertible top headliner.

    For additional information, refer to: Convertible Top Headliner 

scientia non olet · About LEMON Manuals