LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Convertible Top -- XK/X150) >> Convertible Top >> Convertible Top Compartment Lid Release Cables >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible top lid release latch cables.
    • Release from the 7 clips.
  2. Attach the convertible top lid lift cylinder bracket release cables.
    • Loosen the 2 locknuts.
    • Remove the clip.
  3. Attach the convertible top latch release cables.
    • Secure with the clips.
    • Tighten the Torx bolts.
  4. Attach the convertible top lid lift cylinder.
    • Secure with the clip.
  5. Secure the convertible top lid lift cylinder bracket.
    • Remove the 2 lower nuts.
    • Loosen the upper retaining nut.
  6. Secure the convertible top lid position switch.
    • Tighten the Torx bolts.
  7. Secure the LH convertible top lid latch.
    • Tighten the bolts to 10 Nm (7 lb.ft).
  8. Secure the convertible top electrical connector.
    • Connect the electrical connector.
    • Secure with the clip.
  9. Install the RH loadspace trim panel.

    For additional information, refer to: Loadspace Trim Panel - Convertible

  10. Connect the battery ground cable and install the cover.

    For additional information, refer to: Battery Disconnect And Connect

  11. Close the convertible top compartment lid.
  12. If required, adjust the convertible top compartment lid.
scientia non olet · About LEMON Manuals