Removal And Installation: Installation
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
- Install the convertible top latch and cable assembly.
- Attach the emergency release cable.
- Tighten the nuts to 10 Nm (7 lb.ft).
- Secure the convertible top lid RH latch.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Secure the LH convertible top lid latch.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Attach the convertible top lid lift cylinder.
- Secure with the clip.
- Secure the convertible top lid latch and cable assembly.
- Connect the electrical connector.
- Secure the cables in the clips.
- Secure the convertible top electrical connector.
- Connect the electrical connector.
- Secure with the clip.
- Install the RH loadspace trim panel.
For additional information, refer to: Loadspace Trim Panel - Convertible
- Connect the battery ground cable and install the cover.
For additional information, refer to: Battery Disconnect And Connect
NOTE:
Support as necessary.
Close the convertible top compartment lid.
- Raise the rear of the convertible top.