LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Convertible Top -- XK/X150) >> Convertible Top >> Convertible Top Compartment Lid >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the convertible top compartment trim panel.
    • Install and tighten the Torx screws.
    • Secure with the clips.
  2. Install the convertible top compartment moulding.
    • Tighten the nuts to 4 Nm (3 lb.ft).
  3. Install the convertible top compartment lid strikers.
    • Tighten the bolts to 9 Nm (7 lb.ft).
  4. Install the convertible top compartment lid lift cylinder spigot.
  5. Install the convertible top compartment lid pad.
    • Secure with the clips.
  6. Install the convertible top compartment lid buffers.
    • Release the clips.
    • Secure in the clips.
  7. Check the convertible top compartment lid profile.
    • Loosen the locknut.
    • Adjust the striker.
    • Check the convertible top compartment lid profile.
  8. With assistance, install the convertible top compartment lid.
    • Tighten the bolts to 25 Nm (18 lb.ft).
  9. Attach the convertible top compartment lid lift cylinder.
    • Secure with the clip.
  10. Close the convertible top compartment lid.
    • Remove the support.
    • Depress the switch.
  11. If required, adjust the convertible top compartment lid.
scientia non olet · About LEMON Manuals