LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Navigation System -- XK/X150) >> Navigation System >> Navigation System Display Module >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the navigation screen module.
    • Tighten the Torx bolts to 6 Nm (4 lb.ft).
    • Tighten the Torx screws.
    • Install the clip.
  2. Install the navigation system module bracket.
    • Connect the electrical connectors.
    • Tighten the Torx screws.
  3. Install the instrument panel center reinforcement trim panel.
    • Align the pegs and secure with the clips.
  4. Connect the battery ground cable.

    For additional information, Refer To: BATTERY, MOUNTING AND CABLES (Specifications).

scientia non olet · About LEMON Manuals