Pinpoint Test H: No Navigation Voice Guidance
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
- H1: CHECK ALL AUDIO OUTPUT SYSTEMS
- Check audio output across all systems.
Is there sound output across all systems?
- H2: CHECK VOICE GUIDANCE SOFT KEY
- Check navigation screen menu, voice guidance soft key is not set to OFF position.
Is the voice guidance soft key set to OFF position?
- Yes : Set the voice guidance soft key to ON position. Re - check the system
- No : GO to H3.
- H3: VOLUME LEVEL CHECK
- Check the volume level is not set too low.
Is the volume level set too low? Yes
Increase the volume level and re - test vehicle. No Refer to the appropriate system wiring diagrams and check integrity of amplifier and speaker system wiring harness and connectors. GO to H4.
- H4: NAVIGATION VOICE ONLY NOT AUDIBLE
- Press the 'Navigation voice repeat' soft key.
After the navigation voice repeat soft key is pressed, can voice still not be heard even though it has become louder?
- Yes : Check and install a new Navigation Control Module (NCM) as required. Refer to the new module/component installation note at top of DTC Index.
- No : Operation is normal.
NOTE: 15 minutes are required for the program to update. If the engine is accidentally turned OFF, start the engine again, and wait for 15 minutes.