LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Navigation System -- XK/X150) >> Navigation System >> Navigation System (Diagnosis And Testing) >> Diagnosis And Testing >> Pinpoint Tests >> Pinpoint Test E: Vehicle's Current Position Mark Turns Independently

Pinpoint Test E: Vehicle's Current Position Mark Turns Independently

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. E1: VEHICLES CURRENT POSITION MARK TURNS INDEPENDENTLY 
    1. Determine if the ignition status was turned to Auxiliary or On, while the vehicle was in motion with steering turned such as after an engine stall.

    Was ignition status set to Auxiliary or On?

    • Yes  : The angular speed of the vehicle at the time of the ignition status change will be logged as the standard value. To re - set the standard value, turn ignition status to 'OFF' then to 'Auxiliary' or 'On' with the vehicle stationary. Re - test the vehicle.
    • No  : Check and install a new Navigation Control Module (NCM) as required. Refer to the new module/component installation note at top of DTC Index.
scientia non olet · About LEMON Manuals