LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Steering Linkage -- XK/X150) >> Steering Linkage >> Steering Gear Boot >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the steering gear boot.
    • Clean the component mating faces.
    • Carefully secure the clips.
  2. NOTE: Align to the position noted on removal.

    Install the locknut.

  3. Install the tie-rod end. For additional information,

    Refer to: TIE ROD END  (Removal and Installation)

  4. Using only four-wheel alignment equipment approved by Jaguar, check and adjust the wheel alignment.

    For additional information, refer to: Front Toe Adjustment (General Procedures).

scientia non olet · About LEMON Manuals