LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (MULTIFUNCTION Electronic Modules -- XK/X150) >> MULTIFUNCTION Electronic Modules >> Remote Keyless Entry Module >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the keyless entry module.
    • Connect the electrical connectors.
    • Install the screws.
  2. Install the RH side footwell trim panel.
    • Carefully secure the clips.
  3. Connect the battery ground cable and install the cover.

    For additional information, refer to: Battery Disconnect And Connect

  4. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals