LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Body Closures -- XK/X150) >> Body Closures >> Liftgate >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. With assistance, install the liftgate.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    2. NOTE: Support the lifgate as necessary.

  2. Attach the liftgate support struts.

    • Secure with the clips.
  3. Attach the body harness to the liftgate.
    • Secure with the clips.
    • Connect the electrical connectors.
    • Secure the harness grommets into the liftgate.
  4. Disconnect the rear screen electrical connectors.
  5. Install the liftgate lower trim panel.

    For additional information, refer to: Liftgate Lower Trim Panel

  6. Check and adjust the liftgate.

    For additional information, refer to: Liftgate Alignment 

scientia non olet · About LEMON Manuals