Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

Install the secondary hood pads.
- Secure with the clips.
Install the hood pad.
- Secure with the clips.
Install the hood seal.
- Install the clips.
- Attach the hood seal.
Install the hood seal end caps.
- Secure with the clips.
With assistance install and align the hood.
- Tighten the nuts to 25 Nm (18 lb.ft).
- Connect the struts and secure with the clips.
- Connect the struts and secure with the clips.

Align the hood to the pedestrian protection actuators using special tools 501-119.

Insert special tools 501-119 into the pedestrian protection actuators.
Loosen the 8 bolts securing the pedestrian protection actuator stops to the hood.
Gently close the hood so that the pedestrian protection hood stops are aligned to the actuators.
Open the hood.
Tighten the bolts to 10 Nm (7 lb.ft).