LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Body Closures -- XK/X150) >> Body Closures >> Door Check Arm >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the door check strap.
    • Tighten the Torx screws to 10 Nm (7 lb.ft).
    • Tighten the nuts to 25 Nm (18 lb.ft).
  2. Install the front door inner weathershield.
    • Attach the front door interior handle cable.
    • Tighten the Torx bolt to 10 Nm (7 lb.ft).
  3. Secure the front door inner weathershield.
    • Secure the wiring harness clips.
    • Connect the electrical connectors.
  4. Install the window regulator motor.
    • Install and tighten the Torx screws.
    • Connect the electrical connector.
  5. Install the front door trim panel.

    For additional information, refer to: Front Door Trim Panel

scientia non olet · About LEMON Manuals