Vibration Conditions
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
New Constant Velocity (CV) joints should not be installed unless disassembly and inspection revealed unusual wear.
Clicking, popping or grinding noises may be caused by the following:
- Cut or damaged CV joint boots resulting in inadequate or contaminated lubricant in the outboard or inboard CV joint bearing housings
- Loose CV joint boot clamps
- Another component contacting the rear drive half shaft
- Worn, damaged or incorrectly installed wheel bearing, suspension or brake component
Vibration at highway speeds may be caused by the following:
- Out-of-balance front or rear wheels
- Out-of-round tires
- Driveline imbalance
- Driveline run-out (alignment)
NOTE:
Rear drive half shafts are not balanced and are not likely to contribute to rotational vibration disturbance.
Shudder or vibration during acceleration (including from rest) may be caused by the following:
- Driveline alignment
- Excessively worn or damaged outboard or inboard CV joint bearing housing
- Excessively high CV joint operating angles caused by incorrect ride height. Check ride height, verify correct spring rate and check items under Inoperative Conditions
- Excessively worn driveshaft components