LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Audio Unit -- XK/X150) >> Audio Unit >> Audio Unit >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Carefully check the CD access slot in the climatic control assembly is aligned to the CD unit after tightening the screws. This is a visual check only, do not attempt to probe the CD unit with a sharp object or load a CD.

  1. Carefully install the audio/CD module to the climatic control assembly.

    • Tighten the Torx screws.
  2. Install the climatic control assembly and audio/CD module to the module bracket.
    • Install and tighten the navigation screen Torx screws.
    • Install the CD module bracket Torx bolts and tighten to 6 Nm (4 lb.ft).
    • Install the climatic control assembly Torx bolts and tighten to 6 Nm (4 lb.ft).
  3. Install the navigation screen module.

    For additional information, refer to: Navigation System Display Module

  4. Connect the battery ground cable.

    For additional information, refer to: BATTERY DISCONNECT AND CONNECT (G1075549)

  5. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals