Removal And Installation: Removal
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Remove the overhead console.
For additional information, refer to: Overhead Console
Remove the front intrusion sensor.
-
NOTE: Where installed.
Remove the garage door opener module.
Remove the printed circuit board (PCB) cover.
- Using a 5mm drill bit, carefully drill out and remove the 4 plastic fixing heads.
Remove the PCB.
Remove the two switch mouldings.
Remove the foam pad.
Carefully remove sunroof rocker switch for reuse in the new rear switch moulding.
NOTE:
Where installed.
CAUTION:
Make sure that only the head of the fixing is removed. Do not drill any deeper than necessary. Failure to follow this instruction may result in damage to the component.