LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Instrument Panel & Console -- XK/X150) >> Instrument Panel And Console >> Overhead Console Switch Moulding >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Select the correct switch moulding for the vehicle from the parts kit.
  2. Remove any unnecessary switch buttons from the rear moulding using a suitable sharp knife. Take care not to remove any required switches.
  3. Install the sunroof rocker switch.
  4. Install the front switch moulding.
  5. Install the foam pad.
  6. Install the rear switch moulding.
  7. Install the PCB.
  8. G11524456

    Install the cover.

    • Install the 4 Torx screws
    • Tighten to 1.5 Nm.
  9. Install the garage door opener module.
  10. Install the front intrusion sensor.
  11. Install the overhead console.

    For additional information, refer to: Overhead Console 

scientia non olet · About LEMON Manuals