LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Instrument Panel & Console -- XK/X150) >> Instrument Panel And Console >> Instrument Panel Lower Trim Panel >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rheostat switch assembly and align the instrument panel lower trim panel.
    • Secure the switch assembly clips.
    • Connect the switch assembly electrical connector.
  2. Install the instrument panel, lower trim panel.
    • Install and secure the diagnostic socket.
    • Align the clips.
    • Install the Torx screws.
    • Install the Torx bolts and tighten to 6 Nm (4 lb.ft).
  3. Install the MOST diagnostic port.
    • Secure the clip.
  4. Install the driver's side footwell trim panel.
    • Carefully align and secure the clips.
  5. Install the instrument panel driver's side reinforcement trim panel.
    • Align the pegs and secure with the clips.
  6. Install the instrument panel end trim panel.
    • Release the door aperture seal.
    • Carefully align and secure the clips.
    • Install the aperture seal.
scientia non olet · About LEMON Manuals