LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Rear Suspension -- XK/X150) >> Rear Suspension >> Upper Arm >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: The final tightening of the upper arm must be carried out with the vehicle on it's wheels.

  1. Install the upper arm.

    • Tighten the nuts and bolts to 97 Nm (72 lb.ft).
    • Tighten the nut to 90 Nm (66 lb.ft).
    2. NOTE: Align to the position noted on removal.

  2. Connect the brake hose to the brake caliper.

    • Install 2 new sealing washers.
    • Tighten the union to 35 Nm (26 lb.ft).
  3. Install the rear wheel speed sensor lead.
  4. Install the wheel and tire.

    For additional information, refer to: Wheel and Tire

  5. Bleed the brake system.

    For additional information, refer to: Brake System Bleeding

scientia non olet · About LEMON Manuals