LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Rear Suspension -- XK/X150) >> Rear Suspension >> Tie Bar >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Use an additional wrench to prevent the ball joint rotating.

  1. Install the tie rod.

    • Tighten the new inner nut to 90 Nm (59 lb.ft).
    • Tighten the new outer nut to 55 Nm (41 lb.ft).
  2. Install the wheel and tire.

    For additional information, refer to: Wheel and Tire

  3. Using only four-wheel alignment equipment approved by Jaguar, check and adjust the wheel alignment.
scientia non olet · About LEMON Manuals