LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Rear Suspension -- XK/X150) >> Rear Suspension >> Rear Stabilizer Bar Link >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Use an additional wrench to prevent the ball joint rotating.

  1. Install the stabilizer bar link.

    • Tighten the nuts to 48 Nm (35 lb.ft).
  2. Install the wheel and tire.

    For additional information, refer to: Wheel and Tire

scientia non olet · About LEMON Manuals