Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Install the clips.
Install the lower trim panel.
- Tighten the bolts to 6 Nm (4 lb.ft).
Install the parking aid sensor.
- Carefully secure the clips.
- Repeat the above for the other 3 sensors.
Install the bumper insert.
- Install the clips.

NOTE: Do not disassemble further if the component is removed for access only.

Install the wiring harness.
- Connect and secure the electrical connectors.
- Carefully secure the clips.
Install the tire pressure antenna.
- Install the clips.
- Connect the electrical connector.
- Repeat the above procedure for the other side.
With assistance, install the rear bumper cover.
- Install the bolts and tighten to 6 Nm (4 lb.ft).
- Install the wiring harness.
Vehicles with supercharger
Attach the exhaust sound enhancement vacuum pump.
- Connect the electrical connectors.
- Tighten the bolt to 7 Nm (5 lb.ft)
- Secure the wiring harness clip.
All vehicles
Secure the lower edge of the bumper cover.

NOTE: Align to the position noted on removal.

Install the rear lamp assembly.
- Secure with the clip.
- Tighten the nuts to 2 Nm (1.5 lb.ft).
- Connect the electrical connector.
- Repeat the above procedure for the other side.
Install the fender splash shield.
- Tighten the Torx bolts.
- Repeat the above procedure for the other side.
Install the RH rear quarter trim panel.
- Install the clip.
Install the LH rear quarter trim panel.
For additional information, refer to: Rear Quarter Trim Panel - 2-Door
Install the wheels and tires.
For additional information, refer to: Wheel and Tire