Removal And Installation: Removal
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
-
Raise and support the vehicle.
-
Refer to: Headlamp Assembly
- Refer to: Radiator Splash Shield
- Left-hand shown, right-hand similar.
- The step must be carried out on both sides.
Torque Specification: 4 Nm
- Left-hand shown, right-hand similar.
- The step must be carried out on both sides.
Torque Specification: 4 Nm
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
Torque Specification: 4 Nm
- Left-hand shown, right-hand similar.
- The step must be carried out on both sides.
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
- LH illustration shown, RH is similar.
- The procedure must be carried out on both sides.
- If the front bumper mouldings are to be removed from the front bumper cover, discard the mouldings.
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
CAUTION:
Make sure to support the vehicle with axle stands.
NOTE:
The procedure must be carried out on both sides.
NOTE:
NOTE:
NOTE:
CAUTION:
Always protect paintwork and glass when removing exterior components.
NOTE:
Do not disassemble further if the component is removed for access only.
NOTE:
NOTE:
The step must be carried out on all sensors.
CAUTION:
Protect the surrounding paintwork to avoid damage.
CAUTION:
Protect the surrounding paintwork to avoid damage.
NOTE:
NOTE:
NOTE:
NOTE: