General Procedures: Draining
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
-
Raise and support the vehicle.
- Refer to: Air Deflector
- Using a syringe, remove the PAS fluid from the reservoir.
- Make sure that the area around the component is clean and free of foreign material.
- Be prepared to collect escaping fluids.
FILLING
Torque Specification : 20 Nm
- Fill the power steering reservoir.
- Install the vacuum hand pump to the power steering fluid reservoir.
- Apply a vacuum to the power steering fluid reservoir.
- Remove the vacuum hand pump from the power steering fluid reservoir.
- Fill the power steering reservoir.
-
- Run the engine for 30 seconds.
- Turn the steering fully lock-to-lock, stop the engine.
- Install the vacuum hand pump to the power steering fluid reservoir.
- Apply a vacuum to the power steering fluid reservoir.
- Remove the vacuum hand pump from the power steering fluid reservoir.
- Fill the power steering reservoir.
-
- Run the engine for 30 seconds.
- Turn the steering fully lock-to-lock, stop the engine.
- Install the vacuum hand pump to the power steering fluid reservoir.
- Apply a vacuum to the power steering fluid reservoir.
- Remove the vacuum hand pump from the power steering fluid reservoir.
- Fill the power steering reservoir.
-
- Run the engine for 30 seconds.
- Turn the steering fully lock-to-lock, stop the engine.
- Install the power steering fluid reservoir cap.
- Refer to: Air Deflector
WARNING:
Make sure to support the vehicle with axle stands.
CAUTION:
NOTE:
Make sure that the component is clean, free of foreign material and lubricant.
CAUTION:
Fluid must always be present in the reservoir during bleeding.
NOTE:
Apply the maximum vacuum possible on the reservoir for 1 minute.
CAUTION:
Fluid must always be present in the reservoir during bleeding.
NOTE:
Apply the maximum vacuum possible on the reservoir for 1 minute.
CAUTION:
Fluid must always be present in the reservoir during bleeding.
NOTE:
Apply the maximum vacuum possible on the reservoir for 1 minute.
CAUTION:
Fluid must always be present in the reservoir during bleeding.