General Procedures
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
| 57.15.02 | LUBRICATION SYSTEM - DRAIN AND REFILL | 5000 CC, AJ V8 | 0.7 | USED WITHINS |
- Clean power steering fluid reservoir around the filler cap and fluid indicator.
- Check the power steering fluid, if aerated, wait until fluid is free from bubbles then top-up reservoir to UPPER level mark with recommended fluid.
Remove the filler cap and fill to the MAX level mark.
- Install the reservoir filler cap.
- Start the engine and allow to run for 10 seconds, stop the engine.
- Check the power steering fluid, if aerated, wait until fluid is free from bubbles then top-up reservoir to UPPER level mark with recommended fluid.
-
Start the engine and turn steering fully lock to lock, stop the engine.
- Check and top-up power steering fluid level.
- Start and run the engine for 2 minutes, turn the steering fully lock to lock.
- Check and top-up power steering fluid level.
CAUTION:
Fluid must always be present in the reservoir during bleeding.
CAUTION:
Do not hold steering on full lock for longer than 10 seconds.