LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Steering Column -- XK/X150) >> Steering Column >> Steering Column Lower Shaft >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the steering wheel to the straight ahead position.
    2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

  2. Raise and support the vehicle.

  3. G11512374

    Remove the steering column lower universal joint assembly for access.

    • Remove and discard the 2 bolts.
  4. Remove the instrument panel lower trim panel.

    For additional information, refer to: Instrument Panel Lower Trim Panel

  5. Disconnect the steering column lower shaft from the steering column.
    • Remove the bolt.
  6. G11512375

    Remove the steering column lower shaft.

    • Remove the 2 nuts.
    • Release the bearing carrier.
    • Discard the gasket.
    7. NOTE: Do not disassemble further if the component is removed for access only.
G11512376

Remove the bearing carrier.

scientia non olet · About LEMON Manuals