LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Steering Column -- XK/X150) >> Steering Column >> Steering Column Lower Shaft >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bearing carrier.
    • Install a new gasket.
    • Tighten the bolts to 10 Nm (7 lb.ft).
  2. Install the steering column lower shaft.
    • Install a new gasket.
    • Tighten the nuts to 10 Nm (7 lb.ft).
  3. Connect the steering column lower shaft to the steering column.
    • Align the shafts.
    • Tighten the nuts to 30 Nm (22 lb.ft).
  4. Raise the vehicle.
  5. Install the steering column lower universal joint assembly.
    • Align the shafts.
    • Tighten the new bolts to 30 Nm (22 lb.ft).
  6. Install the instrument panel lower trim panel.

    For additional information, refer to: Instrument Panel Lower Trim Panel

scientia non olet · About LEMON Manuals