Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

Refer to: Battery Disconnect and Connect .
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: Power Steering System Filling .
Torque Specification : 11 Nm
NOTE: Do not loosen the bolts more than 2 turns.

Torque Specification : 25 Nm
Lower the vehicle.
Torque Specification : 10 Nm
Torque Specification : 10 Nm
Torque Specification : 25 Nm
WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

CAUTION: Always plug any open connections to prevent contamination.
NOTE:
- Note the fitted position.
- Discard the sealing washers.
Torque Specification : 28 Nm
Raise the vehicle.
Left-hand drive vehicles
CAUTION: Discard the bolt.

NOTE: Note the fitted position.

Torque Specification : 35 Nm
Torque Specification : 100 Nm

All vehicles
Torque Specification : 63 Nm
CAUTION: Support the engine on a jack. The angle may need to be adjusted during this procedure.

Support the engine with the lifting equipment.
Torque Specification : 48 Nm
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
- Using a suitable wooden block, support the engine on the subframe.
- Lower the transmission jack.
Torque Specification : 25 Nm
Torque Specification : 25 Nm
NOTE:
- Note the fitted position.
- RHD shown, LHD is similar.