LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Air Conditioning -- XK/X150) >> Air Conditioning >> Removal And Installation >> Pressure Cutoff Switch (G560837) >> Installation

Pressure Cutoff Switch (G560837): Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Lubricate the O-ring seals with clean refrigerant oil.

    Install the pressure cutoff switch.

    • Clean the components.
    • Install a new O-ring seal.
    • Tighten the cutoff switch to 10 Nm (7 lb.ft).
    • Connect the electrical connector.
  2. Install the air intake duct.
    • Tighten the clips.
    • Tighten the bolt to 10 Nm (7 lb.ft).
  3. Recharge the A/C system.
  4. Install the engine cover.

    For additional information, refer to: Engine Cover (Removal and Installation).

  5. Connect the battery ground cable and install the cover.
scientia non olet · About LEMON Manuals